2024年粉末冶金国際会議

講演情報

General Sessions (Oral) » T8 MIM - New Processing Routes

[T8] MIM - New Processing Routes

Oral

2024年10月15日(火) 14:00 〜 15:40 Room D (3F 304, Conference Center)

Chairpersons: Hidefumi Nakamura (EPSON ATMIX Corporation, Japan), Abu Bakar Sulong (Universiti Kebangsaan Malaysia, Malaysia)

14:20 〜 14:40

[15D-T8-02] Superiority of V-LINE® Injection Molding Machine in Metal Injection Molding for Precise Parts

*Y. Yamazaki1, Y. Kankawa2 (1.Sodick Co., Ltd., Japan, 2.Moulage LLC., Japan)

キーワード:Metal injection molding, V-LINE injection molding machine, MIM green parts

In metal injection molding (MIM), it is important to reduce flash and flow mark as much as possible for high quality and high productivity on each MIM green parts. The back flow that occurs in injection process and the ability of injection response affect flash and flow mark. In this study, the experiment using the spiral-flow tester and the medical clip mold are carried to compare V-LINE injection molding machine (V-LINE) that plasticizes with the single screw and fills with the plunger to In-line injection molding machine (In-line). The experiment using the spiral-flow tester shows that the flow length molded by V-LINE is longer than that one molded by In-line. And the experiment using the medical clip mold shows that V-LINE can reduce flash and flow mark more than In-line.