2024年粉末冶金国際会議

講演情報

General Sessions (Oral) » T8 MIM - New Processing Routes

[T8] MIM - New Processing Routes

Oral

2024年10月15日(火) 14:00 〜 15:40 Room D (3F 304, Conference Center)

Chairpersons: Hidefumi Nakamura (EPSON ATMIX Corporation, Japan), Abu Bakar Sulong (Universiti Kebangsaan Malaysia, Malaysia)

15:20 〜 15:40

[15D-T8-05] DIC Analysis of Large-deflection during Sintering of MIM Compacts

*K. Kudo1, A. Tanaka2, T. Osada3, N. Yodoshi1, K. Shinagawa1 (1.Kyushu University, Japan, 2.Graduate School of Kyushu University, Japan, 3.Tokyu Metropolitan University, Japan)

キーワード:Sintering deformation, Digital image correlation, Metal injection molding. Finite element method,

Powder molded compacts, characterized by low powder filling rates such as Metal Injection Molding (MIM), often exhibit problems with deformation during sintering due to their large shrinkage and low strength. In this study, the Digital Image Correlation method (DIC) was used for in-situ observation of sintering in Ni powder compacts fabricated by MIM to investigate their large-deflection deformation behavior. As a result, it was revealed that there is a time point when the deviatoric vertical strain in the longitudinal direction becomes tensile across the entire base of the molded compacts. This strain distribution was not symmetrical distribution of tensile and compressive strains, as is typically observed in the small deflection deformation of an elastic body. Additionally, a finite element analysis was performed using a plastic deformation model for porous materials, and it was confirmed that similar results were obtained.