IAG-IASPEI 2017

講演情報

Poster

Joint Symposia » J07. Tracking the sea floor in motion

[J07-P] Poster

2017年8月4日(金) 15:00 〜 16:00 Shinsho Hall (The KOBE Chamber of Commerce and Industry, 3F)

15:00 〜 16:00

[J07-P-09] Changes in physical properties of the Nankai Trough megasplay fault induced by earthquakes, detected by continuous pressure monitoring

Chihiro Kinoshita1, Demian Saffer2, Achim Kopf3, Rosner Alexander3, Laura Wallace4, Eiichiro Araki5, Toshinori Kimura5, Yuya Machida5, Reiji Kobayashi6, Earl Davis7, Sean Toczko5 (1.Kyoto University, Kyoto, Japan, 2.Pennsylvania State University, State College, USA, 3.University of Bremen, Bremen, Germany, 4.GNS Science, Lower Hutt, New Zealand, 5.JAMSTEC, Yokohama, Japan, 6.Kagoshima University, Kagoshima, Japan, 7.Geological Survey of Canada, Sidney, Canada)

One primary objective of Integrated Ocean Drilling Program (IODP) Expedition 365, conducted as part of the NanTroSEIZE project, was to recover a temporary observatory, termed the "GeniusPlug" to monitor formation, pore fluid pressure and temperature within a major splay fault that branches from the main plate interface, at a depth of ~400 m below sea floor (mbsf). The instruments were installed in Dec. 2010 and recovered in April 2016, yielding 5.3 years record of formation pressure and temperature within fault zone. Here, we use the pressure timeseries, and in particular the response to ocean tidal loading, to evaluate changes in physical properties of fault zone induced by several regional earthquakes. To accomplish this, we quantify: (1) the amplitude of the formation's response to tidal loading, defined in terms of a tidal loading efficiency, governed primarily by the formation and fluid elastic properties; (2) the phase lag between the ocean tidal signal and the measured response in the observatory, which is governed by a combination of formation hydraulic diffusivity and the relative compressibilities of the formation and sensing volume; and (3) pressure steps associated with earthquakes, identified in formation pressure after removal of the tidal signal. We observe essentially no phase lag, but in for many events we detect both pressure steps and transient decreases in loading efficiency. To reveal the cause of these changes, we investigate the effects of static and dynamic crustal strains. Most of the detected changes represent pressure increases and loading efficiency decreases. We speculate that disruption of grain contacts and subsequent pore collapse induced by dynamic strain produces changes of hydraulic properties in the fault zone. Alternatively, these changes could reflect exsolution of gas from pore fluids that drives pore pressures up while simultaneously reducing loading efficiency by increasing the compressibility of pore filling fluids.