Japan Geoscience Union Meeting 2014

Presentation information

Print

Oral

Symbol S (Solid Earth Sciences) » S-SS Seismology

[S-SS31_30PM1] Comprehensive approach to the intraplate earthquakes

Wed. Apr 30, 2014 2:15 PM - 4:00 PM 502 (5F)

Convener:*Norio Shigematsu(Active Fault and Earthquake Research Center, Geological Survey of Japan, National Institute of Advanced Industrial Science and Technology), Aitaro Kato(Earthquake Research Institute, University of Tokyo), Takuya NISHIMURA(Disaster Prevention Research Institute, Kyoto University), Chair:Takuya NISHIMURA(Disaster Prevention Research Institute, Kyoto University), Haruo Horikawa(Active Fault and Earthquake Research Center, National Institute for Advanced Science and Technology)

3:45 PM - 4:00 PM

[SSS31-P02_PG] Improvement of gas medium triaxial apparatus derived from thermal fluid analysis

3-min talk in an oral session

*Hidetaka SAOMOTO1, Norio SHIGEMATSU1 (1.Active Fault and Earthquake Research Center, AIST)

Keywords:heat, fluid, Navier-Stokes, equation of state, gas medium triaxial apparatus

A huge amount of effort has used to be required for trial productions during the development of experimental apparatus. Since such trial productions generally consume vast time period and cost, the reduction of them is now a significant issue. Numerical modeling such as the finite element simulation (FE) is widely used to reduce them in various engineering fields. Gas medium triaxial apparatus is widely used to determine the mechanical properties of rocks precisely at higher temperature. However, there has been a limitation for the use at the higher temperature in Japan due to the thermal design. In this presentation we plan to improve the gas-medium triaxial appratus derived from thermal fluid analysis based on the finite element simulation.Here, the governing equations for thermal fluid analysis consist of the heat conduction equation, the Navier-Stokes equation and the equation of state. By solving those equations simultaneously, we obtain important physical quantities such as temperature distribution, fluid velocity field, delay of heating, etc. The knowledge derived from the computer simulations are: (1) The argon gas flow hardly has any relation with the temperature distribution on solid materials. (2) The temperatures of adiabatic materials placed near the heat sources are below the maximum operating temperature. (3)A large thermal gradient is observed close to the plastic O-ring. Based on above results, we have attained valuable improvement policies such as replacement of meterials, improvement of radiation factor on the copper jig, etc.