Japan Geoscience Union Meeting 2015

Presentation information

International Session (Poster)

Symbol S (Solid Earth Sciences) » S-IT Science of the Earth's Interior & Techtonophysics

[S-IT03] Structure and dynamics of Earth and Planetary deep interiors

Tue. May 26, 2015 6:15 PM - 7:30 PM Convention Hall (2F)

Convener:*Takashi Yoshino(Institute for Study of the Earth's Interior, Okayama University), Satoru Tanaka(Department of Deep Earth Structure and Dynamics Research Japan Agency for Marine-Earth Science and Technology), Dapeng Zhao(Department of Geophysics, Tohoku University), Masanori Kameyama(Geodynamics Research Center, Ehime University), John Hernlund(Earth-Life Science Institute, Tokyo Institute of Technology)

6:15 PM - 7:30 PM

[SIT03-P01] Continuous measurements of electrical conductivity of synthetic peridotite under changing temperature: Melting effect

*Kenta SUEYOSHI1, Takehiko HIRAGA1 (1.Earthquake Research Institute, The University of Tokyo)

Keywords:electrical conductivity, peridotite, partial melting, melt fraction

Transport properties of the mantle (ex. electrical conductivity, viscosity, and seismic attenuation) sharply changes during ascend of the mantle especially at around mantle solidus. Electrical conductivity is considered to be the most sensitive property to the presence of partial melt. To understand how partial melting changes the conductivity of ascending mantle (ex. mid-ocean ridge), we measured the electrical conductivity of synthesized peridotite samples, which have different manners of melting with temperature, during slow increases and decreases in temperature under atmospheric pressure.
Three types of samples, forsterite (80%) + diopside (20%), forsterite (95%) + diopside (5%) and forsterite (50%) + enstatite (40%) + diopside (10%) with addition of 0.5% spinel, were synthesized from Mg(OH)2, SiO2, CaCO3 and MgAl2O4 powders with particle size of <50 nm. We continuously measured the electrical conductivity of these samples at temperature range from 1100℃ to 1400℃. Microstructures of the samples quenched from above solidus were observed by scanning electron microscopy (SEM) in order to measure the melt fraction.
The electrical conductivity at well below (>50℃) solidus of the forsterite + diopside samples exhibited a linear distribution in their Arrhenius plots indicating that a single mechanism controls. Such linear relationship was no longer observed at higher temperature regime exhibiting its exponential increase until the temperature reached to produce a phase assembly of forsterite + melt. In addition, the grain size dependence on electrical conductivity disappeared at temperature between 1350℃ and 1360℃, indicating that the effective conductive path changed from grain boundary to other path. The result indicates that there is a phase assembly of forsterite + diopside + melt phase at around 1360℃ which has not been appeared in the previously reported phase diagram (Kushiro and Schairer, 1963).
Monotonic increase of electrical conductivity was observed above solidus of the forsterite + enstatite + diopside + spinel sample, and such increment is considered to be strongly related melt fraction changing with temperature, which is supported from SEM observation.