12:39 PM - 12:42 PM
[SSS29-P04] Sample preparation condition for SEM-EBSD: An example of quartz minerals in granite
3-min talk in an oral session
Keywords:SEM-EBSD, colloidal silica, vibratory polishing, thin section
Vibratory polishing were conducted using VibroMetTM 2 vibratory polisher (BUEHLER Inc.) with colloidal silica suspension (Model No.: 5904-S-64, pH: 9.8, particle size: 40 nm) (PRECISION SURFACES INTERNATIONAL Inc.).
Examined conditions of vibratory polishing with colloidal silica suspension were as follows:
Time: 0, 60, 120, 180 minutes
Normal load: weight (200 g)×1, weight (200 g)×3
The EBSD analyses were performed at the Waseda University with an automated electron back-scattered diffraction system (Channel5, HKL) attached to a SEM (HITACHI S-3400N) with a tungsten filament, an accelerating voltage of 25 kV, a working distance of 30 mm, and with the specimens tilted 70o. Coating the specimen with a conductive material such as carbon removes the problem of charge build-up, but reduces the quality of Electron Backscattering Patterns (EBSPs). To eliminate the problem, EBSD analyses were performed under low-vacuum condition (30Pa) without coating. We selected 20 quartz grains per samples under the BSE image and 70×70 μm area with 2 μm step size (total 1225 points) were measured for each grains. To evaluate the effects of the different vibratory polishing steps on EBSD pattern quality, hit rate which is percentage of value of correctly indexed points to total measured points was used.
The results of 0 minute vibratory polished sample (only diamond polishing) shows less than 55% of hit rate. After 60 minutes of colloidal silica polishing, 70% of the points are correctly indexed, while after 180 minutes this value increases to around 80%. Significant difference of effect of weight was not found. This result shows 60 minutes vibratory polishing is enough for EBSD analysis of quartz grain in granite. For another minerals or rock type, further examination might be required.