日本地球惑星科学連合2018年大会

講演情報

[EE] Eveningポスター発表

セッション記号 S (固体地球科学) » S-VC 火山学

[S-VC39] Pre-eruptive magmatic processes: petrologic analyses, experimental simulations and dynamics modeling

2018年5月24日(木) 17:15 〜 18:30 ポスター会場 (幕張メッセ国際展示場 7ホール)

コンビーナ:中村 美千彦(東北大学大学院理学研究科地学専攻地球惑星物質科学講座)、東宮 昭彦(産業技術総合研究所地質調査総合センター)、Shanaka L de Silva (共同)、Costa Fidel(Earth Observatory of Singapore, Nanynag Technological University)

[SVC39-P09] Very shallow magma storage depths at Sakurajima Volcano revealed from melt inclusions and plagioclase-melt hygrometer

*新谷 直己1中村 美千彦1奥村 聡1安田 敦2味喜 大介3井口 正人3下司 信夫4 (1.東北大学大学院理学研究科地学専攻、2.東京大学地震研究所、3.京都大学防災研究所火山活動研究センター、4.産業技術総合研究所地質調査総合センター)

キーワード:Sakurajima Volcano、magma storage depths、water content、melt inclusion、plagioclase-liquid hygrometer

To understand the mechanism of present eruptive activity and to forecast possible future eruptions at Sakurajima Volcano, it is crucial to understand pre-eruptive magmatic conditions of recent Vulcanian and historic Plinian eruptions (AD 1471–1476, 1779–1782, and 1914–1915). Araya et al. (2017, IAVCEI) reported volatile contents of melt inclusions in pyroxene and plagioclase phenocrysts in Plinian pumices (1.4–3.0 wt% H2O in >95% of inclusions, no detectable CO2). These water contents correspond to saturation pressures of 19–74 MPa and 0.9–3.3 km depth. To further constrain pre-eruptive melt water contents, we applied the plagioclase-liquid hygrometer from Waters and Lange (2015, Am. Mineral.) to plagioclase phenocryst rim and neighboring interstitial groundmass glass pairs obtained from historic Plinian and some recent Vulcanian pumices. Calculated melt water contents are interpreted to record final magma emplacement depths at which the phenocryst rims grew. Groundmass glass is dacitic to rhyolitic in composition. Core zones of plagioclase phenocrysts show complex zoning patterns with a wide compositional range (An~50–90). Marginal zones are relatively chemically uniform, with a compositional distribution peak around An53–60. Melt water contents for three Plinian eruptions were calculated to be 1.1–3.6 wt%, irrespective of eruption age, and are in good agreement with water contents determined from melt inclusions. In contrast, calculated melt water contents for Vulcanian eruptions (1.5–3.0 wt%) are higher than measured contents of melt inclusions (mostly less than 1.5 wt%; Sakauchi et al., 2017, JpGU). This is probably related to slower rates of magma ascent in the Vulcanian eruptions compared to the Plinian eruptions. Here, melt inclusions were subjected to diffusive dehydration, whereas dehydration-induced growth of plagioclase rim did not catch up with decompression.
Our petrological investigation demonstrates that both Plinian and Vulcanian magmas were stored at similar depths of ~1–3 km. This storage depth is shallower than previous estimates based on the pressure source for geodetic deformation upon Vulcanian explosions, a seismic attenuation anomaly, and an aseismic zone (4 km; Iguchi et al., 2013, Bull. Volcanol. Soc. Japan). Rather, our analyses suggest storage in a conduit. This is consistent with the observation that the present conduit has a diameter broad enough to supply the historic Plinian eruptions (300–500 m; Iguchi et al., 2013, Bull. Volcanol. Soc. Japan). Earlier work on the 1914–1915 Plinian eruption suggested that magma ascended from the main deep magma reservoir beneath the Aira caldera (~10 km in depth), as ground subsidence was detected around the caldera after the eruption. However, our petrological analyses indicate that the historic Plinian eruptions were fed directly from the thick conduit rather than the main deep reservoir, which recharged the shallower magma feeding system after the eruption. Detailed observation on the shallow conduit system, in addition to the main deep magma reservoirs, may provide essential information to forecast the next large eruption.