[SCG63-P01] 輝石の量比の異なるかんらん岩を用いた鉱物混合層形成に伴う歪弱化の解明
To understand the effects of secondary minerals on the rheological weakening due to phase mixing, we conducted torsion experiments on samples composed of iron-rich olivine + orthopyroxene. Olivine and pyroxene aggregates with volume fractions of pyroxene of fpx = 0.1, 0.3, and 0.4 were deformed in torsion at a temperature of 1200°C and a confining pressure of 300 MPa using a gas-medium apparatus.
The value of the stress exponent, n, decreases with increasing strain, γ, with the rate and magnitude decrease depending on fpx. In samples with larger amounts of pyroxene, fpx = 0.3 and 0.4, n = 3.5 at lower strains (1 < γ < 3) decreasing to n = 1.7 at higher strains (24 < γ < 25). In contrast, for the sample with fpx = 0.1, again n = 3.5 at lower strains decreasing only to n = 3.0 at higher strains. Furthermore, Hansen et al. (2012) determined n = 4.1 with a grain size exponent of p = 0.7 in samples without pyroxene (fpx = 0) independent of strain. For samples with larger fpx, the observed values of n and p indicate that the deformation mechanism changes with increasing strain, whereas for samples with smaller fpx, no change in mechanism occurs.
The microstructures in our samples with larger amounts of pyroxene provide insight into the change in deformation mechanism identified from the experimental results. Elongated olivine and pyroxene grains align nearly parallel to the shear direction with a strong crystallographic preferred orientation (CPO) in samples deformed to lower strains for which n = 3.5. In contrast, mixtures of small, equant grains of both phases, with a nearly random CPO develop in samples deformed to higher strains that exhibit both a smaller stress exponent (n ~ 2) and strain weakening. The microstructural development forming well-mixed fine-grained olivine-pyroxene aggregates can be explained by the difference in diffusivity among Si, Me (= Fe or Mg), and O. These mechanical and associated microstructural properties provide important constraints for understanding rheological weakening and strain localization in upper mantle rocks.
The value of the stress exponent, n, decreases with increasing strain, γ, with the rate and magnitude decrease depending on fpx. In samples with larger amounts of pyroxene, fpx = 0.3 and 0.4, n = 3.5 at lower strains (1 < γ < 3) decreasing to n = 1.7 at higher strains (24 < γ < 25). In contrast, for the sample with fpx = 0.1, again n = 3.5 at lower strains decreasing only to n = 3.0 at higher strains. Furthermore, Hansen et al. (2012) determined n = 4.1 with a grain size exponent of p = 0.7 in samples without pyroxene (fpx = 0) independent of strain. For samples with larger fpx, the observed values of n and p indicate that the deformation mechanism changes with increasing strain, whereas for samples with smaller fpx, no change in mechanism occurs.
The microstructures in our samples with larger amounts of pyroxene provide insight into the change in deformation mechanism identified from the experimental results. Elongated olivine and pyroxene grains align nearly parallel to the shear direction with a strong crystallographic preferred orientation (CPO) in samples deformed to lower strains for which n = 3.5. In contrast, mixtures of small, equant grains of both phases, with a nearly random CPO develop in samples deformed to higher strains that exhibit both a smaller stress exponent (n ~ 2) and strain weakening. The microstructural development forming well-mixed fine-grained olivine-pyroxene aggregates can be explained by the difference in diffusivity among Si, Me (= Fe or Mg), and O. These mechanical and associated microstructural properties provide important constraints for understanding rheological weakening and strain localization in upper mantle rocks.