3:30 PM - 3:45 PM
[SIT28-07] Application of a new anelasticity model to the seismic discontinuity at the lithosphere-asthenosphere boundary
Keywords:anelasticity, premelting, LAB, G-discontinuity, seismic low velocity, seismic high attenuation
Yamauchi and Takei [2016, JGR] measured polycrystal anelasticity at near-solidus temperatures by using a rock analogue (organic polycrystals). We found that anelasticity by grain boundary sliding is significantly enhanced from considerably below the solidus temperature (0.92 < T/Tm; Tm is the solidus). At the same temperatures, viscosity of grain boundary diffusion creep is also significantly reduced. These observations suggest that a structural transition in grain boundary (premelting) occurs below Tm, changing the dynamical properties of the grain boundary. Another important finding is that these premelting effects have large amplitude even for the samples which generate small amount of melt (≈ 0.4%) at Tm. In contrast, the direct effect of melt, such as poroelastic effect, is negligibly small for these samples. Therefore, in the asthenosphere, where melt fraction is expected to be very small [e.g., Hirschmann, 2010, PEPI], the premelting effect dominates over the direct effect of melt.
By parameterizing the experimental results, we obtained a new empirical formula for the polycrystal anelasticity, and applied it to the temperature dependence of the seismic shear wave velocity VS(T) in the Pacific mantle obtained by Priestley and McKenzie [2013, EPSL]. The steep reduction of VS just below the peridotite solidus can be explained well by the premelting effect without invoking melt [Yamauchi and Takei, 2016, JGR; Takei, 2017, Annu. Rev. Earth Planet. Sci.].
In this study, we apply the new anelasticity model to the G-discontinuity. Vertical seismic profile VS(z) was calculated for the oceanic geotherm (50 and 100 Ma) calculated by the cooling plate models and for the peridotite solidus calculated by the thermodynamic models. The results showed that if the solidus temperature is decreased by water, seismic discontinuity (sharp reduction in VS) can be explained by premelting. In addition, the premelting effect can explain high attenuation in the asthenosphere. When present results are compared to the seismological observations quantitatively, the thickness (<≈ 30 km) and depth (≈ 75−100 km) of the predicted discontinuity agree fairly well, but the amount of velocity reduction (<≈ 3%) predicted by the present anelasticity model is smaller. Further parameter studies will be performed by taking into account a possible difference between analogue samples and rocks.