Japan Geoscience Union Meeting 2018

Presentation information

[EJ] Poster

S (Solid Earth Sciences) » S-SS Seismology

[S-SS10] Seismic wave propagation: Theory and Application

Thu. May 24, 2018 3:30 PM - 5:00 PM Poster Hall (International Exhibition Hall7, Makuhari Messe)

convener:Kiwamu Nishida(Earthquake Research Institute, University of Tokyo), Kazuya Shiraishi(Japan Agency for Marine-Earth Science and Technology), Takao Nibe((株)地球科学総合研究所, 共同), Kaoru Sawazaki(National Research Institute for Earth Science and Disaster Resilience)

[SSS10-P13] Preliminary study of the waveform inversion of the structure model using the adjoint kernels computed based on a land-ocean unified 3D structure model at Tohoku-Oki, Japan

*Taro Okamoto1, Hiroshi Takenaka2, Takeshi Nakamura3 (1.Department of Earth and Planetary Sciences, School of Science, Tokyo Institute of Technology, 2.Graduate School of Natural Science and Technology, Okayama University, 3.Earthquake and Tsunami Research Division, National Research Institute for Earth Science and Disaster Resilience)

Keywords:adjoin kernel, three-dimensional finite-difference method, GPU computing

At the subduction zones, the heterogeneous structure strongly affects the propagation of the seismic waves. Such structural effect can cause significant distortions in the waveforms and biases in the estimation of the earthquake source parameters, including the earthquake locations. Thus it is important to construct precise three-dimensional (3D) structure models with which we are able to reproduce the seismic waveforms from the subduction zone earthquakes. In this paper, we study the sensitivity kernels to improve the parameters of the structure model at the Tohoku-oki area of the Japan trench. We generate the sensitivity kernels based on the method presented by Tanimoto and Okamoto (2014). The forward and adjoint wavefields are computed based on a land-ocean unified 3D structure model (Okamoto et al. submitted). Thus the “starting model” of the inversion is a 3D model, not a standard, one-dimensional model. The numerical simulations are performed using the scheme of HOT-FDM (Nakamura 2012) with multi-GPU acceleration (Okamoto et al. 2013) on the TSUBAME supercomputer at Tokyo Institute of Technology. As a preliminary analysis, we selected a single component from a station (TYS from F-net of NIED) for a shallow interplate earthquake on 2003/11/1 (Mw5.8). In order to reduce the biases in the earthquake parameters used in generating the synthetic waveforms, they are estimated by FAMT method (Okamoto et al. 2017) based on the 3D model. We construct the sensitivity kernels of rigidity for frequency components from 0.024 to 0.53 Hz (210 components in total). The size of the target region is 300 km x 350 km in horizontal and 15 km in vertical, and the region is divided into sub-blocks of 50 km x 50 km x 5 km. Then we invert the residuals between the observed and synthetic spectral components (Fourier coefficients) for the rigidity perturbations of the blocks. This preliminary result shows perturbations with amplitudes of about 1 to a few percent at each of the layers. We will presents further inversion analysis and discuss the improvements in the spectral components and waveforms. (We are grateful to NIED for providing the waveform data. This research is partially supported by KAKENHI (16K05535), HPCI System Research Project (Project ID: hp130118) and JHPCN (Project ID: jh170022-NAJ).)