日本地球惑星科学連合2018年大会

講演情報

[JJ] ポスター発表

セッション記号 S (固体地球科学) » S-SS 地震学

[S-SS15] 地震発生の物理・断層のレオロジー

2018年5月21日(月) 15:30 〜 17:00 ポスター会場 (幕張メッセ国際展示場 7ホール)

コンビーナ:向吉 秀樹(島根大学大学院総合理工学研究科地球資源環境学領域)、谷川 亘(国立研究開発法人海洋研究開発機構高知コア研究所)、松澤 孝紀(国立研究開発法人 防災科学技術研究所、共同)、吉田 圭佑(東北大学理学研究科附属地震噴火予知研究観測センター)

[SSS15-P07] Variation in stick-slip behavior with normal stress and loading rate: insights from bi-axial friction experiments on submeter-sized rock samples

*溝口 一生1飯塚 幸子2 (1.財団法人 電力中央研究所、2.株式会社セレス)

キーワード:断層、摩擦、固着滑り挙動、サブメートル岩石試料、室内実験

Stick-slip behaviors of rocks observed in friction experiments, which have been considered to be analogue as earthquake occurrence, are of great interest in understanding the earthquake dynamics that can help predict the timing and the magnitude of impending earthquake. Here, we conducted bi-axial friction experiments on submeter-sized rock with varying loading rate (1µm/s to 1mm/s), normal stress (1MPa to 10MPa), with displacement up to 50mm, in order to examine the variation in their stick-slip behaviors such as recurrence interval, friction level and stress drop.

For the experiments, we used a pair of granite blocks from Tamil Nadu, China, of which the contacting surfaces simulate a fault of 0.5m in length and 0.1m width. The experiments were done using a single direct shear geometry (Yamashita et al., 2015). The sample interfaces were ground with #200 ~ 300 grit abrasive before the experiments. A constant normal stress was applied to the fault using three hydraulic actuators, and one of the blocks was fixed while the other was moved parallel to the longitudinal direction of the fault plane to apply shear load (max=1000kN) on the fault using a servo motor-driven linear actuator. Throughout the experiment, the whole normal and shear forces applied on the fault plane, which were measured by two load cells attached outside of the fault plane, were digitized with a 1–48kHz sampling rate and 24bit resolution.
The results on the behavior variation showed that for the experiments under the same normal stress (1MPa) an increase in loading rate from 1µm/s to 1mm/s caused a decrease in friction coefficient drop (ratio of shear stress to normal stress) from more than 0.4 to less than 0.07, although the maximum friction level is similar value (~ 0.82) between them. Also, the fault at 1mm/s loading rate and 10MPa normal stress produced periodic stick-slip motion with a constant event interval of 0.08 seconds and friction coefficient drop of 0.11, whereas we found irregular stick-slip occurrence with the interval ranging from 0.01 to 0.04 and the drop ranging from 0.02 to 0.07 for the fault at the identical loading rate but the different normal stress (1MPa). We suggest that the stick-slip behaviors on submeter-sized rock samples were dependent on loading rate and normal stress. We will conduct the similar experiments on centimeter-sized sample and compare with the above results on the larger samples to discuss the scale dependence of the stick-slip occurrence.