[SVC41-P46] Topography Effect on Spectral Ratio Analysis of Explosion Earthquakes at Sakurajima Volcano
Keywords:Topography, Spectral ratio method, Sakurajima
We calculate explosion earthquake waveforms by using OpenSWPC (Meada et al, 2017). We input the ground surface topography data from GSI with a resolution of 10 m and bathymetry data from JODC with a resolution of 500 m. We set a 12 km x 12 km x 9 km grids around the center of coordinate at Showa crater. A vertical single force is exerted to generate explosion earthquakes, which has a source duration TR of 0.5 s and a unit force. A homogeneous medium with Vp of 2.5 km/s, Vs of 1.3 km/s, density ρ of 2.0 g/cm3, Qp of 100 and Qs of 70 is assumed. We simulate the explosion earthquake waveforms for different source depths from 0.2 km beneath the summit of Showa crater down to 1 km from the sea level every 0.1 km. The simulated 3-components seismograms are obtained at the three stations (SKRB, SKRC and SKRD), which are located about 3 km away from the active crater (Showa crater). Then, we calculate spectral ratio of the waveforms calculated for shallow depths to the deepest one (1 km from the sea level). The results show the following characteristics: Spectral ratios at shallower depths are larger than those at deeper ones: The spectral ratio of 0.2 km depth from the summit is about 2 times larger than that of 0.6 km below the sea level in the frequency range of about 1-5 Hz. These characteristics are roughly the same as the observed features. These results suggest that the topography of volcano affect the spectral ratios of explosion earthquakes occurring at shallow depths.