11:00 AM - 11:15 AM
[ACC27-08] Experimental study on compaction process of highly porous ice: Implications for density change of icy regolith layer on icy bodies
Keywords:highly porous ice, compaction, creep experiment, sintering duration, icy regolith layer
Snow samples were prepared by filling ice particles with the diameter of ~20 μm into the cylinder mold and by compressing them by a piston into the cylinder with the diameter of 20 mm and the height of 40 mm. The initial porosity was 0.5-0.65. In order to examine the effect of sintering among ice particles on the compression rate, the sintering duration was changed from 0 to 200 hours. We conducted creep tests under constant stresses from 21 to 42 kPa. The displacement of the sample height was measured by a laser or a contact-typed displacement sensors while the diameter change was measured by using images take by a time lapse camera. The temperature was set to be -9and -11 °C.
First, we examined the relationship between the strain in a height direction, dh/h, and that in a horizontal direction (diameter change), dr/r, and found to be (dr/r)=-0.11(dh/h). Thus, the compaction rate, (1/ρ·dρ/dt), was found to be obtained to be -0.78 times the strain rate in a height direction (we call this rate as “compression rate” hereafter), 1/h·dh/h.
Next, we examined the effect of sintering duration on the compression rate. Under same stress condition, the compression rate was smaller as the sintering duration was longer. However, when the sintering duration passed the critical period, the compression rate was nearly constant even if the sintering duration passed longer. This critical period became shorter as the initial porosity was larger. In this study, to exclude the effect of sintering duration on the compression rate, we examined the effects of porosity, stress, and temperature on the compression rate that was expected for the sample sintering at the period loger than the critical period.
We examined the relationship between the compression rate and the porosity, φ, and found that the compression rate could be fitted by the following power equation under a constant stress, irrespective of the initial porosity, 1/h·dh/dt=Bexp(Cφ), where B and C are constants. The constant increased exponentially with the increase of the stress, σ, that is, B∝σn, where n is constant. The constants, C, and n, did not depend on the stress and obtained to be C=24, and n=1.8.
Finally, we evaluated the compaction processes due to self-gravity on the Antarctica and a saturnian icy satellite, Enceladus, by using our obtained empirical equation. We calculated the density and the elevation change of the snow layer on the Antarctica and the icy regolith layer on Enceladus. In this calculation, we assumed that the initial density was homogeneous, 180 kg/m3, in the whole layer and the stress on the ground surface was 100 kPa. In the case of the Antarctica (a layer thickness of 10 m), the density just above the ground surface increased about three times and the thickness was changed to be a half after 100 years. In the case of Enceladus (a layer thickness of 5 km), the thickness was changed to be a half after 100 years, as same as the case of the Antarctica, but the density just above the ground surface increased about only twice and the density in the layer on Enceladus was smaller than that on the Antarctica on the whole.