日本地球惑星科学連合2019年大会

講演情報

[E] ポスター発表

セッション記号 S (固体地球科学) » S-CG 固体地球科学複合領域・一般

[S-CG51] Role of volatiles on Earth and planetary dynamics

2019年5月30日(木) 10:45 〜 12:15 ポスター会場 (幕張メッセ国際展示場 8ホール)

コンビーナ:石井 貴之(バイロイト大学バイエルン地球科学研究所)、大谷 栄治(東北大学大学院理学研究科地学専攻)、中村 美千彦(東北大学大学院理学研究科地学専攻地球惑星物質科学講座)、Mysen Bjorn(Geophysical Laboratory, Carnegie Inst. Washington)

[SCG51-P09] The conditions of sublithospheric diamond formation constrained from ferric iron-rich exsolution from ferropericlase inclusions.

*Caterina Melai1Daniel Frost1Tiziana Boffa Ballaran1Catherine McCammon1 (1.Bayerisches Geoinstitute)

Ferropericlase is apparently one of the more common inclusions to be found in sub-lithospheric diamonds, which are considered to form in the convecting mantle. Although relatively rare, these inclusions have been examined in a number of studies in the hope of providing information on the formation conditions of such deep diamonds, which could potentially be in the transition zone or lower mantle. The wide range of oxide Fe/(Fe+Mg) ratios found has raised the idea that they may form through the oxidation of iron metal. During TEM investigations, however, evidence for the exsolution of Fe2O3-rich phases such as magnesioferrite have been found, which implies that a more complex scenario may be involved. Ferropericlase-magnesiowüstite diamond inclusions are most likely some of the deepest available samples from the mantle and they potentially provide the most direct evidence for deep mantle carbon transport processes. The ferric iron contents of such inclusions alone may not provide a direct estimate for the oxygen fugacity at which the inclusions were trapped, particularly if pressure has a strong effect on the fo2 - Fe3+/Fetot relationship. However, using experimental data it is possible to determine the oxygen fugacity at which the exsolution observed in the diamond inclusions occurred and coupled with the oxide Fe3+/Fetot ratio this could be used to estimate the pressure of formation.

The ferropericlase- magnesioferrite system has been investigated by several studies at room pressure but the stability field of the two components has been shown to become more complicated at high pressure due to the formation of mixed valence oxides. We have combined experimental measurements with thermodynamic modelling in order to address two main questions: at which P, T, fO2 conditions do Fe2O3-rich phases exsolve from ferropericlase? And what is the maximum Fe3+/Fetot ratio of ferropericlase. To answer these questions, multianvil experiments have been performed between 6 – 25 GPa and 1200-1800°C using a starting composition of (Mg86Fe14)O plus 20 % Fe2O3. Pt powder was added to the experiments to act as a redox sensor and minor amounts of Ni, Cr, Mn and Na were also added. Samples were then analyzed with the scanning electron microscope, electron microprobe, Mössbauer spectroscopy and X-ray diffraction. In the recovered experiments ferropericlase coexists with magnetite-magnesioferrite solid solution up to 10 GPa and Mg2Fe2O5-Fe4O5 solid solution at higher pressures. In the calculation of the oxygen fugacity a ferropericlase model in the FeO-Fe2/3O-MgO system was employed and exchange of Mg and Fe2+ in magnetite was accounted for. Oxygen fugacities at which the phases coexist can be calculated in the magnetite-magnesioferrite field using three different equilibria and a quite simple ferropericlase mixing model results in calculated oxygen fugacities that are within 0.1 log units of each other for all three equilibria. The results show that magnetite-magnesioferrite solid solution should not be in equilibrium with ferropericlase in the diamond stability field. Our results imply that the exsolution of Fe3+ rich phases observed in natural samples likely occurred at pressures corresponding to the transition zone or deeper.