日本地球惑星科学連合2019年大会

講演情報

[J] ポスター発表

セッション記号 S (固体地球科学) » S-CG 固体地球科学複合領域・一般

[S-CG58] 脆性延性境界と超臨界地殻流体:島弧地殻エネルギー

2019年5月30日(木) 10:45 〜 12:15 ポスター会場 (幕張メッセ国際展示場 8ホール)

コンビーナ:土屋 範芳(東北大学大学院環境科学研究科環境科学専攻)、浅沼 宏(産業技術総合研究所・再生可能エネルギー研究センター)、小川 康雄(東京工業大学理学院火山流体研究センター)、長縄 成実(国立大学法人秋田大学)

[SCG58-P09] Quantitative evaluation of fracture distribution in granite and the relationship between fracture distribution and physical properties

*角野 愛美1上原 真一2高橋 美紀3北村 真奈美3 (1.東京大学大学院新領域創成科学研究科環境システム学専攻、2.東邦大学理学部生命圏環境科学科、3.国立研究開発法人産業技術総合研究所)

キーワード:花崗岩、亀裂、地熱

Recently, geothermal uses in the depth below the brittle-ductile boundary have been considered for collecting geothermal energy more efficiently than conventional geothermal uses [1]. One of them is supercritical geothermal power generation, which uses supercritical fluid of higher temperature and pressure than conventional type, and therefore output per power plant is expected to be increased [2]. In this geothermal development, there is a plan to artificially create geothermal reservoirs when the geothermal fluid enough for the power generation capacity does not exist in the rock. These artificial reservoirs are planned to be created through processes such as cooling rocks by water injection, emergence of brittle region, causing hydraulic fracturing, and then emergence of high permeability region. Here, crack generation and propagation by injecting water and cooling rock have some possibility of inducing earthquakes. Therefore, it is important to elucidate properties of crack generation and propagation in the rock in this situation. However, these properties have not been understood enough. In addition, clarifying the relationship between properties of crack distributions and elastic wave velocities, which is not established so far, may be of useful for investigating the crack distributions at actual geothermal development sites by elastic wave explorations.
In this study, we generate cracks in granite specimens by heating them up to 550℃ then cooling, and we clarified the relationship between the cooling rate and the conditions of crack distributions in the specimens. We also tried to clarify the relation between the crack conditions and physical properties such as (elastic wave velocity, porosity and elastic properties derived from the elastic wave velocities) .
Cylindrical specimens (20 mm in the diameter and 40 mm in the length) of granite from Oshima, Ehime Prefecture (initial porosity: <0.38 %, P and S wave velocity (VP), (VS) under water saturated condition: 5.96±0.14, 3.10±0.10 km/s, respectively) were used for the experiments. After being heated the specimens, were cooled in three ways with different cooling rates for the surface temperature (approximately 3.3 ℃/min, 17.7℃/min, and 516 ℃/sec). Observations of X-ray CT images revealed that microscopic cracks were generated in the specimens after the heating-cooling processes. Cracks were extracted from this CT images and the number of cracks was measured. The number of cracks per image (20 mm×40 mm) N was 600 < N < 2600, and the faster the cooling rate was, the larger N per unit area was. This is probably because faster cooling rate causes the greater temperature difference between the center and surface of specimens, which causes larger difference in the degree of shrinkage of the minerals constituting the specimens, and then the minerals are easier to be separated from each other. When N is lager, the porosity is larger (0.60 - 0.82%), and VP and VS are smaller (4.63 - 4.86 and 1.69 - 2.15 km/s, respectively). Bulk modulus and shear modulus were decreased from 61 - 65 to 45 - 48 GPa and 24 - 26 to 7 - 13 GPa, respectively, through the heating-cooling processes. In the presentation, we will investigate the relationship between p, a parameter representing the distribution propability of cracks defined by Hestir & Long [3], and physical properties.

References
[1] Muraoka, H., Asanuma, H., Ito, H., 2013, geoscience magazine, 343 - 361.
[2] Yonekura, H., 2016, "TSC Foresight geothermal power generation" overview, https://www.nedo.go.jp/content/100789529.pdf, 1 - 33.
[3] Hestir, K., and Long, J., 1990, Journal of geophysical research, vol. 95, 21, 565 - 21, 581.