[SCG58-24] Stress heterogeneity on shallow decollement controls property of sediments and Very Low Frequency Earthquakes in Nankai Trough
Keywords:Slip and dilation tendencies, physical property of sediments, very low frequency earthquake, Nankai Trough
We used 3D seismic profiles acquired for IODP NanTroSEIZE in the Nankai Trough off Kii peninsula and produced a 3D surface of the shallow decollement. Dip angle and dip azimuth for each 50 m X 50 m patch of the 3D surface were obtained. With focal mechanisms of the VLFEs in the region, regional stress orientations and stress ratio were estimated. Normal and shear stresses normalized by differential stress on each patch were calculated by the relationship between patch orientations and the regional stress. Slip tendency (Ts) and dilation tendency (Td) were also calculated.
The decollement dips in the convergent direction with low angle 0–5 degree in average. Patches with slightly larger dip (10–25 degree) are identified, distributing in NE-SW direction. The regional stress estimated shows relatively horizontal NW σ1and relatively vertical σ3with 0.65 of stress ratio. Tsranges 0.4–0.6 and high or low Tsareas distribute in NE-SW directions repeatedly. Tdranges 0.3–0.7 and the distribution of Tdshows a good agreement with that of Ts.
In the reprocessing on the 3D seismic profiles, the velocity model was also improved using the up-dated technics. Velocity distribution on the shallow decollement was also examined. Velocity ranges 1500-3500 m/s increasing from shallow to deep in broad sense. It is, however, not a simple increase with depth but some high and low velocity areas with NE-SW directions are identified. Using the velocity-porosity-effective pressure relationship from laboratory experiments on the sediments from IODP NantoSEIZE expeditions, the velocity could be converted to porosity and to effective pressure. Porosity ranges from 0.5-5% and effective pressure ranges from 1600-2600 kPa on the decollement. Because the conversion from velocity to others is a kind of linear conversion, the distributions of porosity and effective pressure are the same with that of velocity; NE-SW trend in high and low values. Although the absolute values of these properties could have multiple errors in many procedures, the relative values in spatial relationships can be discussed.
The spatial relationship between Tsand Td, and porosity or effective pressure also represent a consistent distribution. High Tsand Tdareas correspond to the areas with low porosity and high effective pressure (relatively low fluid pressure at a depth). Slips tend to concentrate in the area with high Ts. High Tdarea corresponds to that with high Ts, which implies that the slip zone could be a fluid conduit. Oppositely, low Tsarea has low Tdwhere the fault could be a barrier of fluid migration. In the area with low porosity and high effective pressure, the sediments are relatively lithified than the sediments in the other area. In high Tsand Tdareas enhance the fluid escape to make sediments lithified. The NE-SW directions of the distribution of high Tsand Tdareas shows a good agreement with the direction of VLFEs’ elongated distributions. This suggests that the Tsand Td,determined by the regional stress and the geomorphic features on decollement, may have close relation to VLFEs’ occurrences.