Japan Geoscience Union Meeting 2025

Presentation information

[J] Oral

S (Solid Earth Sciences ) » S-SS Seismology

[S-SS10] Fault Rheology and Earthquake Physics

Fri. May 30, 2025 3:30 PM - 5:00 PM Exhibition Hall Special Setting (3) (Exhibition Hall 7&8, Makuhari Messe)

convener:Ritsuya Shibata(National Research Institute for Earth Science and Disaster Resilience), Michiyo Sawai(Chiba University), Hanaya Okuda(Kochi Institute for Core Sample Research, Japan Agency for Marine-Earth Science and Technology), Kenichi Tsuda(Institute of Technology, Shimizu Corporation), Chairperson:Michiyo Sawai(Chiba University), Hanaya Okuda(Kochi Institute for Core Sample Research, Japan Agency for Marine-Earth Science and Technology)

3:30 PM - 3:45 PM

[SSS10-23] Magnitude distribution during phase transformational faulting: Implication for deep-focus earthquakes

★Invited Papers

*Sando Sawa1, Julien Gasc2, Nobuyoshi Miyajima3, Alexandre Schubnel2, Marie Baisset2,4, Jun Muto1 (1.Deparment of Earth Science, Graduate School of Science, Tohoku Univeristy, 2.Laboratoire de Geologie, Ecole Normale Superieure Paris, 3.Bayerisches Geoinstitut, University of Bayreuth, 4.Géosciences Rennes, Université de Rennes)

Keywords:Deep-focus earthquakes, AE, Stress drop, Phase transformation

Deep-focus earthquakes occur at depths of 300-660 km in subducted slabs. Geophysical observations (e.g., Zhan et al., 2014) and deformation experiments (e.g., Green and Burnley, 1989) suggest that phase transformations from olivine to wadsleyite and ringwoodite are involved in the faulting process. Geophysical observations further indicate that fault geometry influences the b values in the Gutenberg-Richter law for phase transformational faulting. Meanwhile, deformation experiments reveal that b values are also influenced by rock properties, including structural heterogeneity. Rock grain sizes play a crucial role in the transformation rate, impacting the occurrence of faulting. Consequently, grain sizes may also indirectly influence b values.
We conducted deformation experiments on germanate olivine, an analog of silicate olivine, with various grain sizes (almost 10 - 200 μm) to assess the effect of grain size on b values during phase transformational faulting. We used a Griggs-type deformation apparatus and measured acoustic emissions (AE) with a transducer calibrated by laser-doppler interferometry. This calibration enabled the acquisition of AE waveforms in units of velocity (m/s), enabling a comparison to natural earthquakes. Confining pressure, temperature, and strain rate were 1.2-1.5 GPa, 973-1265 K, and 4.2×10-5-1.7×10-4 s-1, respectively. The AEs obtained upon phase-transformational faulting follow the scaling law between stress drop and corner frequencies observed in natural earthquakes. The b values of these AEs also are similar to those of natural deep-focus earthquakes and range from 0.6 to 1.1. In fine-grained aggregates, b-values are smaller than those in coarse-grained aggregates under the same deformation conditions. In fine-grained aggregates, the homogeneous formation of spinel grains at olivine grain boundaries results in lower b values. Conversely, in coarse-grained aggregates, the heterogeneous formation of spinel aggregates inside olivine grains contributes to high b values. Therefore, the heterogeneity of spinel formation appears to be a controlling factor for b values in phase transformational faulting associated with deep-focus earthquakes.

References
Burnley, P., H. W. Green and D. J. Prior (1991), JGR, vol 96, 425-443.
Zhan, Z., Kanamori, H., Tsai, V. C., Helmberger, D. V., & Wei, S. (2014), EPSL, vol 385, 89-96.