JpGU-AGU Joint Meeting 2017

Presentation information

[JJ] Poster

A (Atmospheric and Hydrospheric Sciences) » A-CG Complex & General

[A-CG53] [JJ] Adaptation for climate change and social implementation

Sat. May 20, 2017 3:30 PM - 5:00 PM Poster Hall (International Exhibition Hall HALL7)

convener:Yoichi Ishikawa(JAPAN Agency for Marine-Earth Science and Technology), Shingo Watanabe(Japan Agency for Marine-Earth Science and Technology), KOJI DAIRAKU(National Research Institute for Earth Science and Disaster Resilience)

[ACG53-P08] Uchimizu: A cool(ing) tradition to locally mitigate the urban heat island

*Anna Solcerova1, Tim van Emmerik1, Koen Hilgersom1, Frans van de Ven1,2, Nick van de Giesen1 (1.Delft University of Technology, Water Resources Management, Stevinweg 1, 2628CN Delft, The Netherlands, 2.Deltares, P.O. Box 177, 2600 MH Delft, The Netherlands)

Urban heat island was first described 200 years ago but ways to mitigate heat in urban areas reach much further into the past. Uchimizu is a 17th century Japanese tradition, in which water is sprinkled around houses to cool the ground surface and the air by evaporation. Unfortunately, the number of published studies that have quantified the cooling effects of uchimizu is limited, and only use measurements of the surface temperature, or air temperature at a single height, as a measure of the cooling effect. In this research, a dense three-dimensional Distributed Temperature Sensing (DTS) setup was used to measure air temperature with high spatial and temporal resolution within once cubic meter of air above an urban surface. Six experiments were performed to systematically study the effect of (1) applied water amount, (2) initial surface temperature, and (3) shading on the cooling effect of uchimizu. The measurements showed a decrease in air temperature up to 1.5 K at 2 m height, and up to 6 K for near-ground temperature. Strongest cooling was measured for the experiment performed in the shade. For an amount of water applied of 1 mm and 2 mm, there was no clear difference in cooling effect, but after application of a large amount of water (>5 mm), the strong near-ground cooling effect was approximately twice as high as when only 1 mm of water was applied. The dense measurement grid used in this research also enabled us to detect the rising turbulent eddies created by the heated surface.