[MIS22-P05] Calibration of the borehole pressure gauges installed in the C0002G observatory in the Nankai trough
Keywords:LTBMS, C0002, Nankai trough, pressure sensors, calibration
All pressure sensors are deployed on the ROV platform of the C0002G observatory, but each pressure sensor measure different water pressure depending on its pressure port depth (0 ~ 948 mbsf). One pressure port is located on the ROV platform (seafloor), the others are distributed inside the C0002G borehole and are connected by steel hydraulic lines with valve systems. The valve systems are manually operated by ROV manipulator, and switch target pressures from the pore fluid pressure in the C0002G borehole to the pressure on the seafloor. The valve systems are used for calibrations of the pressure sensors. Changes in relative instrumental drifts are estimated using the data during recording the seafloor pressure, because all the pressure sensors measure a reference seafloor pressure.
We repeatedly calibrated the pressure sensors in the C0002G borehole in the KY14-04, the KY15-05, and the KY15-16 cruise. Because all valve system were not switched during the cruises, instrumental drifts of the two pressure sensors in the borehole were estimated relative to the seafloor pressure sensor. The relative drift rates were estimated to be -3.88 and 2.37 hPa/year, respectively.
Absolute instrumental drifts are necessary to understand long-term and small pressure change. We are developing a mobile pressure gauge to calibrate a pressure sensor on the seafloor. A target accuracy of the gauge is less than 1 hPa. The absolute instrumental drift rates of all pressure sensors in the borehole will be estimated using the data.