JpGU-AGU Joint Meeting 2017

講演情報

[EE] ポスター発表

セッション記号 S (固体地球科学) » S-CG 固体地球科学複合領域・一般

[S-CG67] [EE] 海溝海側で海洋プレートに生じる過程:沈み込み帯へのインプット

2017年5月23日(火) 15:30 〜 17:00 ポスター会場 (国際展示場 7ホール)

コンビーナ:山野 誠(東京大学地震研究所)、森下 知晃(金沢大学理工研究域自然システム学系)、藤江 剛(海洋研究開発機構)、Jason Phipps Morgan(Royal Holloway University of London)

[SCG67-P02] Measurements of thermal conductivity of a basalt core sample retrieved from subducting oceanic crust in Nankai subduction zone under high temperature

*林 為人1,2多田井 修3木下 正高4亀田 純5谷川 亘2廣瀬 丈洋2濱田 洋平2松林 修6 (1.京都大学大学院工学研究科、2.海洋研究開発機構高知コア研究所、3.マリンワークジャパン、4.東京大学地震研究所、5.北海道大学大学院理学研究科、6.産業技術総合研究所)

キーワード:thermal conductivity, high temperature, basalt

Knowledge of rock thermal conductivity is a key to understand thermal structure in active seismogenic zones such as the Nankai Trough subduction zone, SW Japan. To estimate thermal conductivity at the oceanic crust surface in the seismogenic zone, we measured the thermal conductivity of a basalt core sample retrieved from subducting oceanic basement at a depth of ~573 mbsf in input site C0012 of the Nankai Trough Seismogenic Zone Experiment (NanTroSEIZE) under high temperature (maximum 160°C). The high temperature condition corresponds to that at the oceanic crust surface in the updip limit of the Nankai seismogenic zone (~7 km below the seafloor). Thus, we set our high temperature condition of the thermal property measurements up to 160°C at atmospheric pressure for a dry basalt core sample, and up to 100°C for a wet basalt core sample at the same pressure condition.
As results of the experiments, thermal conductivity of the dry basalt core sample under high temperature and atmospheric pressure gradually increased with increasing ambient temperature. The thermal conductivity of the wet sample also showed an increasing trend, but the value measured at 100°C might be strongly influenced by the evaporation of pore water, and consequently revealed a sharp increase between 80 and 100°C. The thermal conductivity of the wet basalt was ~1.62 W/mK at room temperature. Under atmospheric pressure condition we could not measure the thermal conductivity of the wet basalt at 160°C, but we estimated the value to be ~1.77 W/mK based on both measured thermal conductivity of the dry basalt sample and literature thermal conductivity data of pore water at the same temperature 160°C. Generally, for other rock types such as sandstone and granite, however, their thermal conductivity decreases with increasing temperature, in contrast to the thermal conductivity of the oceanic basalt increased with increasing ambient temperature.
The thermal conductivity at ~7km also depends on the in situ pressure condition. We will also show our estimation of the thermal conductivity at ~7km in Nankai subduction zone not only for high temperature but also for high pressure effects.