JpGU-AGU Joint Meeting 2017

講演情報

[EE] ポスター発表

セッション記号 S (固体地球科学) » S-IT 地球内部科学・地球惑星テクトニクス

[S-IT22] [EE] 核-マントルの相互作用と共進化

2017年5月21日(日) 13:45 〜 15:15 ポスター会場 (国際展示場 7ホール)

コンビーナ:土屋 卓久(愛媛大学地球深部ダイナミクス研究センター)、寺崎 英紀(大阪大学大学院理学研究科)、Satish-Kumar Madhusoodhan(Department of Geology, Faculty of Science, Niigata University)、入舩 徹男(愛媛大学地球深部ダイナミクス研究センター)、Hernlund John(Earth-Life Science Institute, Tokyo Institute of Technology)、大谷 栄治(東北大学大学院理学研究科地学専攻)

[SIT22-P46] Melting experiments of plagioclase under the shock-vein conditions

*周 佑黙1入舩 徹男2,3大藤 弘明2新名 亨2 (1.愛媛大学大学院理工学研究科、2.愛媛大学地球深部ダイナミクス研究センター、3.東京工業大学地球生命研究所)

キーワード:Plagioclase, High Pressure and High Temperature, Phase Relation, Shock Metamorphism

High-pressure phase transitions of minerals have been frequently observed in heavily shocked meteorites, mainly within or around the shock veins (e.g., Chen et al. 1996). The plagioclase entrained in or adjacent to the shock veins transformed into maskelynite (e.g., Chen and El Goresy 2000), lingunite (e.g., Gillet et al. 2000) or jadeite plus amorphous materials (Miyahara et al. 2013). These transformations likely occurred in solid state, and the processes could be highly affected by the crystallization kinetics, as demonstrated by the kinetics studies of Kubo et al. (2010, 2016) at 18-25 GPa below 1673 K. On the other hand, the shock-metamorphic products of plagioclase exhibit some melting features (e.g., Chen and El Goresy 2000), and it is also likely that the shock metamorphism of plagioclase proceeded under the shock-vein conditions, typically 20-24 GPa and 2273-2673 K (Chen et al. 1996). Thus, high-temperature studies are necessary for further understanding the shock metamorphism of plagioclase in heavily shocked meteorites.

In this study, subsolidus and melting phase relations of Ab85An10Or5 (oligoclase, the typical composition for the plagioclase found in heavily shocked meteorites) have been investigated by multi-anvil experiments at 16-23 GPa and 2273-2700 K. At 19-22 GPa, the subsolidus phase assemblage of Ab85An10Or5 is jadeite (Jd) + stishovite (St) + hollandite (Holl) + CAS phase, and the melting sequence is Jd (the solidus phase), Holl, CAS phase and St (the liquidus phase). The liquidus temperature of Ab85An10Or5 is at least 100 K higher than that of KLB-1 peridotite at 19-22 GPa. If the liquidus temperature of KLB-1 peridotite is used to infer the shock-vein temperatures, and if oligoclase completely melted at 19-22 GPa during impact, the oligoclase needed to be hotter than the shock veins, and therefore a localized heating in oligoclase is essential. It is found that Na-rich Holl and Na-rich CAS phase are stable in the composition of Ab85An10Or5 at 22 GPa and ~ 2500 K; the silicate liquid formed by melting crystallized into Holl, CAS phase and St during quenching. These phenomena likely relate with the natural occurrence of lingunite (e.g., Gillet et al. 2000) and CAS phase (Beck et al. 2004) in heavily shocked meteorites, but the kinetics problem must be further discussed. In addition, the intergrowth of CAS phase and St observed in some Martian meteorites (Beck et al. 2004) has been reproduced by quenching a labradorite melt at 23.5 GPa.