JpGU-AGU Joint Meeting 2017

講演情報

[JJ] ポスター発表

セッション記号 S (固体地球科学) » S-SS 地震学

[S-SS17] [JJ] 地震発生の物理・断層のレオロジー

2017年5月21日(日) 13:45 〜 15:15 ポスター会場 (国際展示場 7ホール)

コンビーナ:松澤 孝紀(国立研究開発法人 防災科学技術研究所)、飯沼 卓史(国立研究開発法人 海洋研究開発機構)、谷川 亘(国立研究開発法人海洋研究開発機構高知コア研究所)、向吉 秀樹(島根大学大学院総合理工学研究科地球資源環境学領域)

[SSS17-P08] Stress condition around M6.5 earthquake fault of the 2016 Kumamoto earthquake sequence

*光岡 郁穂1松本 聡2山下 裕亮3中元 真美4宮崎 真大3酒井 慎一5飯尾 能久32016年熊本地震 合同地震観測グループ (1.九州大学、2.九州大学大学院理学研究院附属地震火山観測研究センター、3.京都大学防災研究所、4.国立極地研究所、5.東京大学地震研究所)

The 2016 Kumamoto earthquake sequence occurred at Hinagu and Futagawa fault zones under tectonic stress condition of strike slip or normal fault type. First large earthquake with magnitude 6.5 on April 14, 2016 was located at Hinagu fault zone with high seismic activity prior to the event. The stress condition around the fault zone is important to understand the generation of the earthquake. Especially, it is a key factor estimating the spatial variation of stress field at the depth of the hypocenter.
In this study, we estimated the deviatoric stress field and the stress ratio around Hinagu fault zone from focal mechanisms. We used the method estimating it from seismic moment tensor data (Matsumoto, 2016). The data were selected from focal mechanisms of earthquakes occurring from May 2016 to December 2016 at a depth range of 0-20km. We found that the stress field with strike-slip fault regime at the 0-5km depth area. This principal direction is similar to commonly observed in Kyushu Island, Japan. However, the stress field in the area deeper than 5km was in normal fault regime. The maximum principal compressional stress was close to the moderate one at the area. This area corresponds to the co-seismic large slip area estimated from the kinematic waveform inversion of strong motion data (Asano and Iwata, 2016). This suggests that the spatial change in the stress could be caused by decreasing the differential stress at the area deeper than 5km. The stress field around Hinagu fault zone was in strike-slip regime before the occurrence of the M6.5 event and changed to normal fault stress type due to the slip of the event.