The 63rd JSAP Spring Meeting, 2016

Presentation information

Oral presentation

10 Spintronics and Magnetics » 10.1 Emerging materials in spintronics and magnetics (excluding semiconductors)

[21a-W241-1~12] 10.1 Emerging materials in spintronics and magnetics (excluding semiconductors)

Mon. Mar 21, 2016 9:00 AM - 12:00 PM W241 (W2・W3)

Taro Nagahama(Hokkaido Univ.)

10:45 AM - 11:00 AM

[21a-W241-8] Antiperovskite ferromagnetic MnGaN films with perpendicular magnetic anisotropy

〇(PC)Hwachol Lee1, Hiroaki Sukegawa1, Jun Liu1,2, Zhenchao Wen1, Tadakatsu Ohkubo1, Shinya Kasai1, Seiji Mitani1,2, Kazuhiro Hono1,2 (1.MMU, NIMS, 2.Univ. of Tsukuba)

Keywords:MnGaN,Antiperovskite,perpendicular magnetic anisotropy

The search of new perpendicular magnetic materials such as D022 Mn3Ga[1] with low magnetization (Ms), high spin polarization (P) [2], low Gilbert damping α [3] and high perpendicular magnetic anisotropy (PMA)[4] has been of great concern in order to establish a high performance and high thermal stability of perpendicular magnetic tunnel junction (p-MTJ) for a future spin transfer torque (STT)-magnetic random access memory (MRAM) device. In this work, we report the newly-found ferromagnetic (FM) MnGaN exhibiting perpendicular magnetic anisotropy (PMA) with the a cubic antiperovskite E21 structure [5]. Mn-Ga-N films were prepared by RF reactive sputtering technique with N2 flow rate percent (η) relative to 30 sccm Ar gas and a Mn60Ga40 sputtering target. 50 nm thick MnGa-N films were grown on an MgO(001) substrate with varied substrate temperatures. The films were evaluated by X-ray diffraction (XRD), atomic force microscopy (AFM) and scanning transmission electron microscopy (STEM). The film grown at 480°C and η = 1% showed a single phase E21 antiperovskite (an Mn3GaN structure) and epitaxial growth with (001) orientation, confirmed by XRD and a nano-beam diffraction (NBD) pattern of STEM as shown in the inset (a) of Fig. 1. The composition was determined to be Mn67Ga24N9, showing an N deficient composition. Figure 1 shows the magnetic hystereses of the film at 300 K. Interestingly, the film shows ferromagnetism with a relatively high Curie temperature up to 740 K and PMA characteristics regardless of the antiferromagnetism in stoichiometric Mn3GaN bulk. Ms of 80 kA/m was also observed, which was lower than the value of a D022 Mn2.4Ga (η = 0% case) film (200 kA/m). The spin polarization evaluated using a point contact Andreev reflection spectroscopy (PCAR) reveals the relatively high spin polarization of 57%, as seen in the inset (b) of Fig. 1. In addition, the MnGaN film was found to exhibit very smooth surface morphology with the average roughness of 0.4 nm. These results suggest ferromagnetic E21 MnGaN will be a promising PMA material for future STT-MRAM application. This study was partly supported by Samsung Electronics.
References: [1] B. Balke et al., Appl. Phys. Lett. 90, 152504 (2007). [2] H. Kurt et al., Phys. Rev. B 83, 020405 (2011). [3] S. Mizukami et al., Phys. Rev. Lett. 106, 117201 (2011). [4] F. Wu et al., Appl. Phys. Lett. 94, 122503 (2009). [5] H. Lee et al., Appl. Phys. Lett. 107, 032403 (2015).