General Session » Additive Manufacturing

General Session: Additive Manufacturing II

Tue. May 21, 2024 2:45 PM - 3:55 PM Room III (2F、Room 202)

Chairperson:Weiwei ZHOU(Tohoku University)

+Add all to schedule

2:45 PM - 2:55 PM

[3-14B] Oxygen concentration of water atomized SUS316L powder manufactured by laser powder bed fusion

*Akihiro Hirayama¹, Takahiro KANEYOSHI¹, Akihiko YANAGITANI², Tohru YAMASAKI¹ (1. Hyogo Prefectural Institute of Technology, 2. Research Center for Advanced Metallic Materials, University of Hyogo)

2:55 PM - 3:10 PM

[3-15A] Effect of laser processing parameters on residual stress and mechanical properties of a hot work tool steel produced by laser powder bed fusion

*Yoshiki Kumagai¹, Kosuke Tomiyama¹, Akito Yorichika¹ (1. Daido Steel Co., Ltd.)

3:10 PM - 3:25 PM

[3-16A] Nritriding treatment of 18%Ni maraging steel samples manufactured by pulsed current sintering and metal additive manufacturing

*Nazuna IDETA¹, Yen-Rin KUO¹, Makoto NANKO¹, Tsuyoshi SUGIMOTO² (1. Nagaoka University of Technorogy, 2. National Institute of Technology, Asahikawa College）（※This presenter is a candidate for the Student Award for Outstanding Presentation.)

3:25 PM - 3:40 PM

[3-17A] Development of hierarchical porous Cu by annealing and selective etching of L-PBF processed Cu-Al alloy

*Hiroki OKA¹, Shaoyun ZHOU¹, Asuka SUZUKI¹, Naoki TAKATA¹, Makoto KOBASHI¹ (1. Nagoya University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.)

3:40 PM - 3:55 PM

[3-18A] Promotion of impact solidification in aerosol deposition via particle design

*Anna Ikehata¹, Go Kawamura¹, Atsunori Matsuda¹, Wai Kian Tan¹, Hiroyuki Muto¹ (1. Toyohashi University of Technology）（※This presenter is a candidate for the Student Award for Outstanding Presentation.)

Session information