Session information

特別セッション

特別セッション » 時代の要求に対応する今後の射出成形技術

時代の要求に対応する今後の射出成形技術

Wed. Jun 21, 2023 11:00 AM - 12:20 PM Room A (3階　瑞雲)

座長:金藤芳典(三菱電機株式会社)

+Add all to schedule

11:00 AM - 11:20 AM

[A-105] Influence of Counter Pressure Mold on surface properties in Injection foamed molding

*Shota Tanaka¹, Masakatsu Taga², Masahiro Seto¹, Atsushi Mizutani², Masashi Yamabe¹ (1. Kanazawa Institute of Technology, 2. Nissan Motor Corporation)

11:20 AM - 11:40 AM

[A-106] Improving of Strength around Flow Front Meeting Area in Molded Products by Core Pin Driving Method inside Injection Mold

*tomohiro hishida¹, atsushi motegi¹, yasuhiko murata² (1. PLAMO Co., Ltd, 2. Nippon Institute of Technology)

11:40 AM - 12:00 PM

[A-107] Visualization analysis of filling behavior in cavities for thick-walled molding Ⅲ

*Hideaki Kato¹, Hidetoshi Yokoi² (1. Institute of Industrial Science, The University of Tokyo, 2. YOKOI Labo)

12:00 PM - 12:20 PM

[A-108] Correlation Analysis between Compensation Flow and Dimensional Accuracy in Thick-wall Molded Products (Part II)

*Yuki Nishiyama¹, Michihiro Tatsuno², Hidetoshi Yokoi³ (1. SEKISUI CHEMICAL Co., Ltd., 2. TOKYO Univ., 3. YOKOI Labo)

Authentication

Abstract password authentication.
Password is required to view the abstract. Please enter a password to authenticate.

Please log in with your participant account.
» Participant Log In

▲