11:00 AM - 11:20 AM

[A-105] Fabrication of Gas Permeable Hybrid Molds with Sub-Micro Structures to Develop Antimicrobial Properties by Injection Molding

*Naoto Sugino¹, Rio Yamagishi², Sayaka Miura², Mano Ando², Yuna Hachikubo², Yuki Kawano³, Yoshiyuki Yokoyama³, Takao Kameda¹, Satoshi Takei² (1. SANKOGOSEI ltd., 2. Toyama prefectural University, 3. Toyama Industrial Technology Research and Development Center)

11:20 AM - 11:40 AM

[A-106] Sub-Micro Structure Transfer Pattern of PolyPropylene Molded Product using Gas Permeable Polymer-Metal Hybrid Mold

*Naoto Sugino¹, Rio Yamagishi², Sayaka Miura², Mano Ando², Yuna Hachikubo², Yuki Kawano³, Yoshiyuki Yokoyama³, Takao Kameda¹, Satoshi Takei² (1. SANKOGOSEI ltd., 2. Toyama prefectural University, 3. Toyama Industrial Technology Research and Development Center)

11:40 AM - 12:00 PM

[A-107] Correlation Analysis between Melt Flow Behavior and Irregular Gloss Pattern around Stepped Thickness Reduction Area

*Wataru Nonaka¹, Michihiro Tatsuno², Hidetoshi Yokoi³ (1. Olympus Corporation, 2. Institute of Industrial Science, the University of Tokyo, 3. YOKOI Labo)

12:00 PM - 12:20 PM

[A-108] Measurement of temperature distributions inside flowing melts injected from nozzle (Part 4)

*Michihiro TATSUNO¹, Yokoi Hidetoshi² (1. The University of Tokyo, 2. YOKOI Labo)

Session information

深化と進化、未来を創る両利きの射出成形技術

[A-105] Fabrication of Gas Permeable Hybrid Molds with Sub-Micro Structures to Develop Antimicrobial Properties by Injection Molding

[A-106] Sub-Micro Structure Transfer Pattern of PolyPropylene Molded Product using Gas Permeable Polymer-Metal Hybrid Mold

[A-107] Correlation Analysis between Melt Flow Behavior and Irregular Gloss Pattern around Stepped Thickness Reduction Area

[A-108] Measurement of temperature distributions inside flowing melts injected from nozzle (Part 4)

Authentication