Session information

Tweet

一般セッション

General Session » Injection molding

射出成形

Wed. Nov 29, 2023 10:10 AM - 10:50 AM Room F (Rehearsal room)

座長:木原伸一(広島大学)

+Add all to schedule

10:10 AM - 10:30 AM

[F-203] Measurement of temperature distributions inside flowing melts injected from nozzle (Part 3)

*Michihiro TATSUNO¹, Hidetoshi YOKOI² (1. The University of Tokyo, 2. YOKOI Labo)

10:30 AM - 10:50 AM

[F-204] Visualization analysis on generation phenomena of inhomogeneous surface defects in PMMA molded samples with polymer particle diffusers

*Hideaki Kato¹, Hidetoshi Yokoi² (1. Tokyo Univ., 2. YOKOI Labo)

×

Authentication

Abstract password authentication.
Password is required to view the abstract. Please enter a password to authenticate.

×

Please log in with your participant account.
» Participant Log In