2019年第80回応用物理学会秋季学術講演会

講演情報

一般セッション(口頭講演)

9 応用物性 » 9.2 ナノ粒子・ナノワイヤ・ナノシート

[20a-E317-1~9] 9.2 ナノ粒子・ナノワイヤ・ナノシート

2019年9月20日(金) 09:00 〜 11:30 E317 (E317)

加納 伸也(産総研)

09:15 〜 09:30

[20a-E317-2] Pulsed discharging of compacted B powder for B nanoparticle preparation

HIEU DUY NGUYEN1、CHU MINH NGO1、YOSHINORI TOKOI2、THI-MAI-DUNG DO1、TADACHIKA NAKAYAMA1、HISAYUKI SUEMATSU1、KOICHI NIIHARA1 (1.Nagaoka Univ. Tech.、2.National Inst. Tech., Oyama College)

キーワード:B nanoparticles, Pulsed wire discharge

Pulsed wire discharge is a physical vapor method for preparing nanoparticles. In this method, a thin metallic wire is vaporized by a large pulsed current and rapidly quenched in ambient gas/liquid to form nanoparticles. Because of the necessity of wire, some materials such as silicon, boron, etc are difficult to draw wire so it was a challenge for PWD to prepare such materials. Recently, by discharging through a thin Al wire penetrating a heat-shrinkable tube filled with Si micron powder, it was able to prepare Si nanoparticles [1]. By using this method, efforts to prepare B nanoparticles were done using Al, Zr, Mo, and W wires. Experimental apparatus is shown in Fig. 1. Either compacted powder in a heat-shrinkable tube with Al, Zr, Mo, W wires or Ti, Fe, Cu rods was used for raw materials. The capacitors were charged at 6.2 kV and discharged in Ar gas at 100 kPa. By compressing B powder with a pair of Ti, Fe, and Cu rods and discharging, B nanoparticles were successfully prepared with Cu rods. With Ti rods, discharge was unable to occur and with Fe rods, a large amount of compounds of Fe and B were formed. From XRD pattern in Fig. 2, by using B micron powder as a raw material and Cu rods for compressing, B nanoparticles were successfully prepared
[1] S. Ishihara et al., Materials Letters, 67, pp. 289-292 (2012).