日本地球惑星科学連合2018年大会

講演情報

[JJ] ポスター発表

セッション記号 S (固体地球科学) » S-VC 火山学

[S-VC41] 活動的火山

2018年5月23日(水) 13:45 〜 15:15 ポスター会場 (幕張メッセ国際展示場 7ホール)

コンビーナ:前田 裕太(名古屋大学)、三輪 学央(防災科学技術研究所)、青木 陽介(東京大学地震研究所、共同)、西村 太志(東北大学大学院理学研究科地球物理学専攻)、大倉 敬宏(京都大学大学院理学研究科附属地球熱学研究施設火山研究センター)、奥村 聡(東北大学大学院理学研究科地学専攻地球惑星物質科学講座)、小園 誠史(東北大学大学院理学研究科地球物理学専攻)

[SVC41-P47] Average magma ascent rate and xenolith-entrained depth constrained by thermal effect on crustal xenoliths

*川畑 博1西村 光史2堀江 憲路3竹原 真美3 (1.高知大学 理工学部、2.東洋大学 経済学部、3.国立極地研究所)

キーワード:ゼノリス、部分溶融、熱履歴

Xenoliths are one of the important sources for clues on crustal structure and magma ascent rate. However, determination of xenolith-entrained depth is not straightforward especially for thermally affected xenoliths, in which mineral assemblage and compositions have been modified. In addition, commonly used Stokes' settling law only indicates the minimum magma ascent rate required to transport xenoliths to the surface. To overcome some of the limitations, we considered the timescale of heat transfer and disequilibrium phenomena of xenolith melting. We performed a non-steady-state 1-D thermal conduction model in spherical coordinates, varying initial temperature conditions and xenolith size. The model involves latent heat of fusion and temperature-dependence of thermal conductivity. Boundary conditions specified temperature, where xenolith surface has constant temperature as the host magma. This implicitly assumes that the xenoliths are volumetrically insignificant. Melt productivity in xenolith, which is also essential in the calculation, is based on phase equilibria but the effect of disequilibrium melting is also considered. Therefore, melt proportions at a given position increase by increasing both the degree of superheating and the heating time until melt proportions reach the values expected from phase equilibria. As an example, the above model was applied for Cretaceous granitic xenoliths entrained in a Miocene intermediate dike in NE Shikoku, SW Japan. Unknown initial xenolith temperature (T0) was estimated using a xenolith entrained-depth and a geotherm gradient for shallow crust (30°C/km). For xenoliths with 10–60 cm in diameter and T0 of 40–460°C enclosed by a host magma with 900°C, it took ~0.3–12 hours to reach solidus temperature at the xenolith center. If disequilibrium melting is assumed, longer time (order of days) is required for 5% melting at the xenolith center. Based on the resultant timescale, we can constrain the combination of average magma ascent rate and entrained-depth that explains the observed xenolith texture (i.e., the presence or absence of glass at the center of a xenolith). The approach proposed here would be applicable for other crustal xenoliths as long as the xenoliths were entrained in ascending magmas.