2018年第79回応用物理学会秋季学術講演会

講演情報

一般セッション(口頭講演)

22 合同セッションM 「フォノンエンジニアリング」 » 22.1 合同セッションM 「フォノンエンジニアリング」

[20p-234B-1~17] 22.1 合同セッションM 「フォノンエンジニアリング」

2018年9月20日(木) 13:15 〜 18:00 234B (234-2)

渡邉 孝信(早大)、山本 貴博(東理大)、宇治原 徹(名大)

14:00 〜 14:15

[20p-234B-4] Fabrication process and thermal conductivity measurement setup of graphene phononic crystal.

〇(D)Mayeesha Masrura Haque1、Seiya Kubo1、Marek E. Schmidt1、Shinichi Ogawa2、Hiroshi Mizuta1,3 (1.JAIST、2.AIST、3.Hitachi Cam. Lab)

キーワード:Phononic crystal, Suspended graphene nanomesh, Heat spreader method

High frequency phonons are responsible for heat conduction in semiconductors and dielectric materials. Fabrication of phononic crystals (PnCs) has become a subject of interest in the scientific community for the potential it offers for heat propagation control. Fabrication of intricate nanopatterns on materials like silicon and steel has long since been realized with the optimization of various focused ion beam (FIB) techniques. Recently, graphene has garnered much interest for room temperature phononic applications due to its high Young’s modulus (~1 TPa) and Debye temperature (~2800 K), which resulted in various attempts in fabricating graphene PnCs. Fabricating nanopore arrays in suspended graphene with sub-10-nm pitch by direct focused helium ion beam milling (HIBM) has recently been demonstrated by our lab. The heat spreader method has recently been applied to measure the thermal conductivity of graphene and ultrathin graphite. In this method, a temperature gradient is created in the investigated material by applying current through a heater electrode while monitoring the voltage changes in adjacent electrodes due to temperature change. The heaters and thermometers are fabricated on silicon substrate using e-beam lithography (EBL). To separate graphene from the conducting metal layer, an insulating layer will be transferred and patterned. Finally, graphene will be transferred, pattered and suspended by HF release which will later be exposed to HIBM to create the nanomesh. In our presentation, we will report on our progress regarding fabrication and measurement.