Special Session » Recent Advances of Materials and Technologies on Additive Manufacturing

Special Session: Recent Advances of Materials and Technologies on Additive Manufacturing

Tue. Nov 19, 2024 4:20 PM - 5:35 PM Room I (2F, Room 201)

Chairperson:Kenta YAMANAKA(Tohoku University, Japan)

+Add all to schedule

4:20 PM - 4:35 PM

[1-19A] Exploration on β Stabilizing Elements of α+β Titanium Alloys for Promotion of Martensite Decomposition in Additive Manufacturing 《 Synthesis Process 》

*Takuma Teramae¹, Ammarueda Issariyapat², Shota Kariya², Junko Umeda², Katsuyoshi Kondoh² (1. Graduate School of Engineering, Osaka University, 2. Joining and Welding Research Institute, Osaka University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.　)

4:35 PM - 4:50 PM

[1-20A] Microstructure Analysis of α+β Ti-2Mn Alloy Additively Manufactured with In Situ Martensite Decomposition 《 Synthesis Process 》

*Takuma Teramae¹, Ammarueda Issariyapat², Shota Kariya², Jyunko Umeda², Katsuyoshi Kondoh² (1. Graduate School of Engineering, Osaka University, 2. Joining and Welding Research Institute, Osaka University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.　)

4:50 PM - 5:05 PM

[1-21A] Changes of cohesive strength and powder bed condition by adjusting the surface oxide layer of Ti-6Al-4V alloy powders for additive manufacturing 《 Physical Property, Evaluation Technology 》

*Naoki Kakegawa¹, Weiwei Zhou¹, Naoyuki Nomura¹ (1. Tohoku University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.　)

5:05 PM - 5:20 PM

[1-22A] Effect of material parameters on force-displacement curves in particle compression tests using FEM simulation 《 Evaluation Technology 》

*Shoma Sekita¹, Zhang Tao¹, Weiwei Zhou¹, Naoyuki Nomura¹ (1. Tohoku University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.)

5:20 PM - 5:35 PM

[1-23A] Microstructure and mechanical property of additive manufactured Nb alloy and Ta alloy 《 Sintering, Physical Property 》

*_ Suyalatu¹, Kazuto Arakawa², Hideki Wakabayashi², Yasuko Ueda², Norio Higuchi¹, Hitoshi Sakai¹, Yugo Higashida³, Masato Inata³ (1. NTT DATA XAM Technologies Corporation, 2. Shimane University, 3. KIGUCHI TECHINCS inc.)

Session information