General Session » Forming and Sintering

General Session: Forming and Sintering

Tue. Nov 19, 2024 9:15 AM - 10:35 AM Room III (3F, Room 301)

Chairperson:Sota TERASAKA(Japan Fine Ceramics Center)

+Add all to schedule

9:15 AM - 9:30 AM

[3-1A] DIC analysis of sintering deformation behavior in stepped powder compacts with inhomogeneous density distribution 《 Sintering 》

*Yamato Ikeda¹, Kentaro Kudo², Noriharu Yodoshi², Kazunari Shinagawa² (1. Graduate School of Kyushu University, 2. Kyushu University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.)

9:30 AM - 9:45 AM

[3-2A] mechanical performance evaluation of micro-powder using force-displacement curve obtained from compression tests 《 Physical Property, Evaluation Technology 》

*Tao ZHANG¹, Weiwei Zhou¹, Naoyuki Nomura¹ (1. Tohoku University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.)

9:45 AM - 10:00 AM

[3-3A] Hot compressive deformation behavior of metallic glass composites under rapid heating condition. 《 Sintering 》

*Tatsuya Kikkawa¹, Noriharu Yodoshi², Kentaro Kudo², Kazunari Shinagawa² (1. Graduate School of Kyushu University, 2. Kyushu University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.)

10:00 AM - 10:10 AM

[3-4B] A fast and accurate method for density measurement 《 Evaluation Technology 》

HIROFUMI SHINTOKU¹, *AKIRA SHIMADA¹ (1. TOYOTA MOTOR CORPORATION)

10:10 AM - 10:25 AM

[3-5A] Influence of Pore Size Distribution on Fatigue Strength in Injection Molded High-Hardness Steel 《 Sintering, Physical Property 》

*Hayato Koyaishi¹, Kentaro KUDO², Noriharu YODOSHI², Kazunari SHINAGAWA² (1. Graduate School of Kyushu University, 2. Kyushu University）（※This presenter is a candidate for the Student Award for Outstanding Presentation.)

Break（10min） (10:25 AM - 10:35 AM)

Session information