2017年第64回応用物理学会春季学術講演会

講演情報

一般セッション(口頭講演)

8 プラズマエレクトロニクス » 8.2 プラズマ診断・計測

[15a-301-1~7] 8.2 プラズマ診断・計測

2017年3月15日(水) 09:00 〜 10:45 301 (301)

石川 健治(名大)

09:15 〜 09:30

[15a-301-2] Behavior of Electron and Negative Ion Density in Very High Frequency Capacitively Coupled Plasma

堤 隆嘉1、Sirse Nishant2、Ellingboe Albert2、Sekine Makoto1、Hori Masaru1 (1.Nagoya Univ.、2.Dublin City Univ.)

キーワード:negative ion, electron density, plasma

A very high frequency (VHF), 30 - 300 MHz, capacitively coupled plasma (CCP) have proved to be useful plasma processing tool for semiconductor fabrication due to the enhanced process rates and lower plasma induced damage. Generally, higher plasma density and lower electron temperature are realized as increasing the driving frequencies. Moreover, a pulsed plasma is known to satisfy requirements such as charging-free plasma processes for high-aspect-ratio hole etching processes. In this study, we present experimental results for the measurement of negative ion densities in a CCP discharge driven at 60 MHz or 100 MHz frequency in both CW and pulsed mode.
Electron and negative ion densities in O2 and Ar/O2/C4F8 plasma were measured using a hairpin probe and pulse laser photo-detachment method. Wavelengths used in the photo-detachment were 532, 355 and 266 nm in order to measure negative ions (O-, F- etc) generated in the plasma. The effects of RF frequency, power, duty ratio for 1-kHz pulsed plasma on negative ion generation were examined as well as the gas pressure. In the CW O2 plasma, the electron (ne : 2×1010 to 5×1010 cm-3) and O- density (n- : 1×1010 to 3×1010 cm-3) increased with an increase in the VHF power (100 to 500 W) and decreased slightly (ne : 3×1010 to 2×1010 cm-3, n- : 1.3×1010 to 0. 9×1010 cm-3) with an increase in the gas pressure (1 to 10 Pa). In the CW Ar/O2/C4F8 plasma, the total negative ion density increased and O- density decreased (~50%) with an increase in power from 50 to 300 W because F- were mainly produced by the dissociative attachment of fluorocarbon radicals. The F- densities were further measured by performing photo-detachment at higher laser wavelength and observed a linear increase in F- density with the increase in power.